Month: February 2022

Sleeve Length for Drop Shoulder

I need to finish the last Saddle Up pullover. I’m so close but I now know that I’m missing some important information. How long should the sleeves be? I have his sleeve measurement for a raglan but a drop shoulder length is different.

Using my best guess, I knit the sleeves to just above the cuff. They look too long to me. I need to do a fitting before I work the cuffs. Yesterday I dumped the pullover in the sink and laid it out to dry. The cables have relaxed nicely.

What I should have done at the beginning was measure him from the centre back of neck to his wrist. That’s a really good way to get the sleeve measurement for a drop shoulder.

These are the measurements I have for average adults for centre back of neck to wrist.

Women: centre back of neck to wrist

Petite; Regular; Tall
29”/74cm; 30”/76cm; 31”/79cm


Men: centre back of neck to wrist

Short; Regular; Tall
30”/76cm; 31.5”/80cm; 32.5”/83cm

After blocking I measured his sweater from the centre back of neck to the end of the sleeve (sans cuff) and I get 29″/74cm. I think he’s a regular size so I may be in the ball park after all. A 3″/8cm cuff may just finish it off nicely. Fingers crossed.

Cheers, Deb

Any Gauge and Gauge-Free patterns by Deb

Behind the design

When I was designing this Saddle Up …

… I had a vague picture in my head, of another sweater. I knew it was an Elizabeth Zimmermann design and every once in a while I would wonder where I had seen it. I didn’t look for it, I just kept it there in my head. Yesterday I rooted around in my book library and I found it here.

https://www.ravelry.com/patterns/sources/knitting-workshop-updated-edition

It was the Gaffer’s Gansey.

Now that I’m looking at this sweater, I’m chuckling to myself as I see that it doesn’t really resemble my finished pattern. But the starting point was there. It was the sideways garter stitch saddle that caught my attention years ago and recently popped into my head again. The saddle idea would not go away. It needed to be knit.

The gansey above is knit bottom up with the saddles worked last. My Saddle Up is turned on its head. It’s worked mostly top down, for any gauge of yarn, and for any size. The saddle is worked first, from one shoulder to the other. The width of the saddle is used to determine the final size of the pullover. Then stitches are picked up off of the edges of the saddle and the rest of the pullover is knit down.

It’s curious how the mind works. I started with a very vague idea about that garter stitch saddle and then wondered how I could make it Gauge-Free and for any size. There we have it, two sweaters with similar saddles but each worked with a different style of construction.

I hope you are also enjoying your knitting through this cold winter. Cheers, Deb

Any Gauge and Gauge-Free patterns by Deb

%d bloggers like this: